the motion control company
(888) 777-1826
+1 (818) 222-9200

Home About Us Site Map Contact Us
Products
Motion Controllers
Solenoid Control Electronics
Linear/ Rotary Actuators and Stages
Motors
Power Supplies
Motor Drivers
Accessories
Two-axis Joystick
Three-axis Joystick
Trackball
Operator Interface Terminal
Switch Selector
Knowledge Center
Motion Control Components
About Us
Site Map
Videos

 

High Performance Solenoid Driver, Pick and Drop Module

Data Sheet in PDF

Similar Solenoid Controller and Driver Products

Pick and Hold Module 
Proportional (PWM) Module
Closed Loop Solenoid Position Control Module
Pick and Drop Module
Load On-Off Power Cycling Module
Dual Proportional Valve Controller
Solenoid Control System
Related Products
RS232 Control Module
Power Supplies

 

 

Features
  • Low Cost
  • Small Size 
  • Low Weight
  • Highly Efficient
  • Stand Alone
  • Microcomputer Based, May Be Re-programmed for Your Application
  • Highly Reliable
  • Pulse Width Modulated (PWM)
  • Single Supply, from +9 VDC to +50 VDC
  • High Supply Voltage, +50 VDC
  • High Output Current 15 Amps Peak, 4 Amps RMS
  • RoHS Compliant 
  • QUANTITIES AVAILABLE IN STOCK
 
Typical Applications
  • Solenoids
  • Valves
  • Relays
  • Actuators
  • Voice Coil Actuators
  • DC Motors
  • Hydraulics
  • Electromagnets
  • LEDs

General Specifications

  • Supply Voltage, +9 to +50 VDC
  • Peak Current, 15 Amp
  • Average Current, 4 Amp
 
The Pick and Drop Driver Module applies a single pulse to the device, then drops the supply voltage to zero.

This is done by applying a signal to the trigger input of the module.

The trigger voltage could be a TTL / CMOS compatible signal or any voltage between 3.0 VDC and the DC power source supply voltage .

The pick time is set using an onboard potentiometer and can be adjusted up to one minute.

The OES' RS232 Control Module could be used to control up to sixteen Pick and Drop Modules.
This product is RoHS complaint.

Performance Specifications

Parameter

Min

Typical

Max

Units

Supply Voltage

9

 

50

VDC

Peak Current

 

 

15

Amp

Average Current

 

 

4

Amp

Command Range

3

 

50

VDC

Operating Temperature 

0

 

50

Deg C

Performance Table

Part No. Input Signal Pick Voltage Pick Time Drop Voltage
PDD-xx Pulse, 3-50 VDC Equal to Power Supply Voltage Variable, Set by a Trim Potentiometer, 2 milliseconds and one minute. Zero

Timing Diagram

 

 

 

 

 

 

Mechanical Specifications

Mounting Pattern Four 6-32 Screws
Dimensions 3.00”W, 2.95”D, 0.85”H (76.2 mm, 75.0 mm, 21.5 mm)

Ordering Information


Part No. Description Amount
PDD-01 Single-device High Performance Pick and Drop Solenoid Driver Module $103.35
PDD-02 Two-device High Performance Pick and Drop Solenoid Driver Module $129.18
 

 


Home | Products | Accessories | Tech Support |About Us | Terms of Use |Testimonials | Site Map | Contact Us
Optimal Engineering Systems, Inc.
Los Angeles, California, USA

Toll Free Number (888) 777-1826 in USA

+1 (818) 222-9200

Support@OESincorp.com

Please contact us for a customized solution.

Copyright ©  1998 - 2012 Optimal Engineering Systems, Inc.,
All Rights Reserved