Please use the following comparison table to find the product
that meets your requirements.
 |
|
Item Number |
Series |
Mode of Operation |
Controller |
Driver |
Power Supply |
Number of Devices |
|
1
|
Pick and Hold Module
 |
Requires External Pulse
Input |
- |
Yes |
- |
Up to 2 |
|
The
Pick and Hold
Solenoid Driver Module is designed to avoid
over heating of the solenoid coil once it is energized.
|
|
|
|
Item Number |
Series |
Mode of Operation |
Controller |
Driver |
Power Supply |
Number of Devices |
|
2
|
PWM Module
|
0-5
VDC Input Signal
or
4-20 milliamps Input Signal
or
External Potentiometer
or
Onboard Potentiometer |
- |
Yes |
- |
Up to 2 |
|
The PWM Module is designed to enable the user to vary
the voltage across a solenoid or other devices.
The PWM output voltage is
proportional to the input control voltage.
|
|
|
|
Item Number |
Series |
Mode of Operation |
Controller |
Driver |
Power Supply |
Number of Devices |
|
3
|
Pick and Drop Module
|
Requires External Trigger
Input |
- |
Yes |
- |
Up to 2 |
|
The Pick and Drop Driver Module applies a
single pulse to the device, then drops the supply voltage to zero.
|
|
|
|
Item Number |
Series |
Mode of Operation |
Controller |
Driver |
Power Supply |
Number of Devices |
|
4
|
Load On-Off Power Cycling Module
|
Built-in Signal Generator
|
Yes, Limited Functionality |
Yes |
- |
Up to 2 |
|
The Load On-Off Cycling Module is designed to enable
the user to cycle the voltage across a solenoid or other devices.
The
frequency of actuation, the output
peak voltage. and the duty cycle of
the actuation (ratio of on time to the length of one full cycle) are
adjusted using the onboard potentiometer. |
 |
|
Item Number |
Series |
Mode of Operation |
Controller |
Driver |
Power Supply |
Number of Devices |
|
5
|
Ethernet-compatible
Module |
Pick and Hold
Pick and Drop
Proportional Control
Load On-Off Power Cycling
|
Yes, Limited Functionality |
Yes |
- |
Up to 2 |
|
|
 |
|
Item Number |
Series |
Mode of Operation |
Controller |
Driver |
Power Supply |
Number of Devices |
|
5
|
RS232 Control Module |
Externally Controlled
Stand-alone
|
Yes |
- |
- |
Up to 16 |
|
This card may be used to control multiple units
of Pick and Hold, Pick and Drop and PWM modules. |
 |
|
Item Number |
Series |
Mode of Operation |
Controller |
Driver |
Power Supply |
Number of Devices |
|
6
|
Solenoid Control System
|
Externally Controlled
Stand-alone |
Yes |
Yes |
Yes |
Up to 32 |
|
The compact and stand-alone unit consists of
controller, drivers and the power
supplies.
|
|
